Canister Purge Solenoid: Testing and Inspection

COMPONENT INSPECTION
EVAP Canister Purge Control Solenoid Valve
With Consult
1. Jack up driving wheels (M/T models only).
2. Turn ignition switch "ON".




3. Select "PURG CONT S/V" of "ACTIVE TEST" mode with CONSULT.
4. Start engine and warm it up sufficiently.




5. Disconnect vacuum hose at EVAP canister purge control valve.
6. Touch "ON" and "OFF" and check for vacuum passing through the hose.

Condition / Vacuum
2,000 rpm (A/T models) / Not exist
2,000 rpm with 1 gear position (M/T models) / Exist

OR

Without Consult







Check air passage continuity.
If NG, replace solenoid valve.