Auto Lock Free Running Hub

REPLACEMENT
Refer to the illustrations when servicing, noting the following:
1. Set auto-lock free-running hub in the FREE position.





2. Remove auto-lock free-running hub with brake pedal depressed.





3. Remove snap ring.
4. Remove washer B. washer A and brake B.
5. After installing auto-lock free-running hub, check operation.
^ When installing it, apply recommended grease to the parts shown in the above illustration.





INSPECTION
^ Thoroughly clean parts with cleaning solvent and dry with compressed air.
^ Measure the thickness "L" of brake "A" and "B". If thickness is less than the specified limit, replace brake "A" and "B" as a set.