Case Components

1. Remove rear extension.
a. Remove control housing, check ball, return spring plugs, select check plungers and return springs. Also remove reverse check plug, check spring and check ball.
- Be careful not to lose check balls.





b. Drive out striking lever retaining pin.
c. Remove striking lever from striking rod.
d. Remove rear extension by lightly tapping on it.





2. Remove front cover, gasket, countershaft front bearing shim and main drive gear ball bearing snap ring.
3. Separate transmission case from adapter plate by lightly tapping on it.





4. Remove oil seal from front cover.
- Be careful not to damage mating surface of front cover.