LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 1997 >> D21 Hardbody XE 2WD L4-2389cc 2.4L SOHC MFI (KA24E) >> Repair and Diagnosis >> Powertrain Management >> Ignition System >> Crankshaft Position Sensor >> Testing and Inspection

Crankshaft Position Sensor: Testing and Inspection

COMPONENT INSPECTION
Crankshaft position sensor (OBD)
1. Disconnect crankshaft position sensor (OBD) harness connector.
2. Loosen the fixing bolt of the sensor.
3. Remove the sensor.




4. Visually check the sensor for chipping.




5. Check resistance as shown in the figure.

Resistance: Approximately 166.5 - 203.5 ohms at 20°C (68°F)

scientia non olet · About LEMON Manuals