Spark Plug: Service and Repair

Spark Plug Wire Removal:

1. Disconnect ignition wires from spark plugs at boot. Do not pull on the wire.




2. Remove spark plugs with spark plug socket.




3. Check gap of each new spark plug.
- Use a wire brush for cleaning, if necessary.

Gap: 1.0 - 1.1 mm (0.039 - 0.043 in)

4. Install spark plugs. Reconnect ignition wires according to numbers indicated on them.

Spark plug: 20 - 29 Nm (2.0 - 3.0 kg-m, 14 - 22 ft-lb)




Spark Plug Application Chart