Interior - Wind Noise Field Fix Procedures
Classification: BT95-002aReference: NTB95-052a
Date: July 5, 1995
WIND NOISE FIELD FIX PROCEDURE
This amended version of NTB95-052 presents new information concerning the Applied Date. Please discard NTB95-052.
APPLIED VEHICLES:
1995 Sentra (B14)
1995 200SX (B14)
APPLIED DATE:
Vehicles built on and after November 1, 1994
SERVICE INFORMATION
Ȁlq:
&�lq:
�{mq:
��mq:
]#nq:
If customers complain of excessive wind noise, please carry out the relevant field fix procedure from the chart in this bulletin. The customer complaint must be identified (speed, area, noise) before the specific repair is performed.
Be sure to verify this is not an incident caused by crosswind.
SERVICE PROCEDURE
Perform the relevant field fix from the chart in this bulletin.
For any operations involving the use of foam tape: Remove any incorrectly positioned
foam tape. Install new 1/4" wide by 1/8" thick single-sided adhesive foam tape as needed.
(cut from 3M SCOTCH FOAM # 4508 or equivalent).
CLAIM INFORMATION
Please refer to the current "Nissan Flat Pate Manual" and select the claims coding that best reflects the operation(s) performed.
NOISE SOURCE LOCATIONS
(Refer to Check Point Numbers)