Without CONSULT

FINAL CHECK (WITHOUT CONSULT)
1. Erase the diagnostic test mode II (Self-diagnostic results) memory from Engine Control Module (ECM).
2. Start engine and warm it up sufficiently.
3. Perform test drive in "D" position for at least 12 seconds continuously in the following conditions.

Engine speed: 1,900-2,500 rpm
Vehicle speed: 76 100 km/h (47-62 MPH)

4. Stop the vehicle, turn ignition switch "OFF" and wait for at least 3 seconds. Then turn ignition switch "ON".
5. Perform "Diagnostic Test Mode II (Self-diagnostic results)" with ECM.