With Manufacturer's Scan Tool (CONSULT)

HOW TO CLEAR DIAGNOSTIC TROUBLE CODES (WITH CONSULT)
The diagnostic trouble code can be erased by the following methods.
^ If the battery terminal is disconnected, the diagnostic trouble code will be lost within 24 hours.
^ When you erase the DTC, using CONSULT it is easier and quicker than switching the mode selector on the Engine Control Module (ECM).

1. If the ignition switch stays "ON" after repair work, be sure to turn ignition switch "OFF" once. Wait for at least 3 seconds and then turn it "ON" again.
2. Turn CONSULT "ON" and touch "ENGINE".
3. Touch "SELF-DIAG RESULTS".
4. Touch "ERASE". (The DTC in the ECM will be erased.)
Touch "BACK" twice.
5. Touch "ENGINE".
6. Touch "SELF-DIAG RESULTS".
7. Touch "ERASE". (The DTC in the ECM will be erased.)