Without CONSULT

DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE
1. Start engine and run it at idle for at least 2 seconds.
2. Perform "Diagnostic Test Mode II" (Self-diagnostic results) with Engine Control Module (ECM).

1. Start engine-and warm it up sufficiently.
. Turn ignition switch "OFF" and wait for at least 3 seconds.
3. Start engine again and run it for at least 30 seconds at idle speed.
4. Turn ignition switch "OFF", wait for at least 3 seconds and then "ON".
5. Perform "Diagnostic Test Mode II" (Self-diagnostic results) with ECM.