Without CONSULT

DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE
1. Turn ignition switch "ON", and wait for at least 6 seconds.
2. Start engine and wait for at least 3 seconds.
3. Turn ignition switch "OFF", wait for at least 3 seconds and then turn "ON".
4. Perform "Diagnostic Test Mode II" (Self-diagnostic results) with Engine Control Module (ECM).

1. Turn ignition switch "ON".
2. Start engine and warm it up sufficiently.
3. Wait for at least 10 seconds at idle speed.
4. Turn ignition switch "OFF", wait for at least 3 seconds and then turn "ON".
5. Perform "Diagnostic Test Mode II" (Self-diagnostic results) with ECM.