Assembly

ASSEMBLY
1. Install side gears and thrust washers in differential case.
2. Install pinion mate gears and thrust washers in the differential case while rotating them.
- Apply ATF to all parts.





3. Measure clearance between side gear and differential case with washers.

Clearance between side gear and differential case with washers:
0.1 - 0.2 mm (0.004 - 0.008 in)





- If not within specification, adjust clearance by changing thickness of side gear thrust washers.

Side gear thrust washer: Refer to SDS.





4. Install retaining pin.
- Make sure that retaining pin is flush with case.





5. Install speedometer drive gear on differential case.
- Align projection of speedometer drive gear with groove of differential case.








6. Press differential side bearings on differential case.





7. Install final gear and tighten fixing bolts in numerical order.