Collision Diagnosis

COLLISION DIAGNOSIS

To repair the SRS "AIR BAG", perform the following steps.

When air bag deployed in a collision

(l) Replace the diagnosis (control) unit.
(2) Remove the air bag module.
(3) Check the SRS components using the table shown below:
- If the SRS components are showing any visible damage such as dents, cracks, or deformation, replace them with new ones.

(4) Conduct self-diagnosis using CONSULT or "AIR BAG" warning lamp to ensure entire SRS operates properly except open circuits of air bag module.
(5) Install new air bag module.
(6) Conduct self-diagnosis again.

When air bag did not deploy in a collision





(l) Check the SRS components using the table shown above.
- If the SRS components are showing any visible damage such as dents, cracks, or deformation, replace them with new ones.

(2) Conduct self-diagnosis using CONSULT or "AIR BAG" warning lamp to ensure entire SRS operates properly.