Disassembly

DISASSEMBLY
1. Check operation of forward clutch and overrun clutch.





a. Install bearing retainer on forward clutch drum.
b. Apply compressed air to oil hole of forward clutch drum.
c. Check to see that retaining plate moves to snap ring.





d. If retaining plate does not move to snap ring, D-ring or oil seal may be damaged or fluid may be leaking at piston check ball.





2. Remove snap ring for forward clutch.
3. Remove drive plates, driven plates, retaining plate and dish plate for forward clutch.





4. Remove snap ring for overrun clutch.
5. Remove drive plates, driven plates, retaining plate and dish plate for overrun clutch.





6. Set Tool on spring retainer and remove snap ring from forward clutch drum while compressing return springs.
- Set Tool directly above return springs.
- Do not expand snap ring excessively.
7. Remove spring retainer and return springs.





8. Remove forward clutch piston with overrun clutch piston from forward clutch drum by turning it.





9. Remove overrun clutch piston from forward clutch piston by turning it.





10. Remove D-rings and oil seals from forward clutch piston and overrun clutch piston.