Case Components

1. Install front cover oil seal.
- Apply multi-purpose grease to seal lip.
2. Install selected counter gear front bearing shim onto transmission case.
- Apply multi-purpose grease.
3. Apply sealant to mating surface of transmission case.




4. Install gear assembly onto transmission case.
5. Install check spring and check ball into interlock stopper.
- Apply multi-purpose grease to check ball.




6. Install interlock stopper assembly and then tighten check ball plug.
- Apply sealant to thread of check ball plug.




7. Install stopper ring and main drive bearing snap ring.




8. Install front cover and gasket.
- Apply sealant to thread of 3 bolts shown left.
9. Apply sealant to mating surface of adapter plate.




10. Install rear extension (or OD gear case) together with striking arm.




11. Install retaining pin into striking arm.




12. Install return spring and check ball and then install control housing.
- Apply sealant to mating surface of rear extension (or OD gear case).




13. Tighten control housing bolts.

Bolt head size:
A bolts 12 mm (0.47 in)
B bolts 13 mm (0.51 in)