Tightening Specifications

Tighten cylinder head bolts in numerical order using ST10120000 (J24239-01).







1. Tighten all bolts to 29 Nm (22 ft lb).

2. Tighten all bolts to 59 Nm (43 ft lb).

3. Loosen all bolts completely.

4. Tighten all bolts to 29 Nm (22 ft lb).

5. Turn all bolts 60 to 65 degrees clockwise.

If an angle wrench is not available, tighten all bolts to 54 to 64 Nm (40 to 47 ft lb).