Master Cylinder Service

PROCEDURES
1. Check for applicable Technical Service Bulletins (TSB).
2. Perform Initial Test Drive and Diagnosis By Symptom.
Testing and Inspection

3. Inspect master-cylinder.
Brake Master Cylinder

4. Remove master-cylinder.
Brake Master Cylinder

5. Rebuild or replace master-cylinder as necessary.
Brake Master Cylinder

6. Adjust master-cylinder pushrod.
Brake Master Cylinder

7. Bleed and Install master-cylinder.
Brake Master Cylinder

8. Bleed front and rear brakes.
Brake Master Cylinder

9. Adjust rear brakes.
Brake Master Cylinder

10. Install tire and wheel assembly.
Brake Master Cylinder

11. Adjust parking-brake.
Parking Brake System

12. Perform After Repairs Test Drive.
Testing and Inspection

ENVIRONMENTAL AND SAFETY CONCERNS