2WD

CAUTION:
- Carefully monitor brake fluid level at master cylinder during bleeding operation.
- If master cylinder is suspected to have air inside, bleed air from master cylinder first.
- Fill reservoir with new brake fluid DOT 3. Make sure it is full at all times while bleeding air out of system.
- Place a container under master cylinder to avoid spillage of brake fluid.
- Rear Wheel Anti-Lock Brake system: Before bleeding air, be sure to turn ignition switch "OFF" and disconnect battery ground cable and actuator connector.






BLEEDING ORDER
- Left rear brake
- Right rear brake.
- Left front brake.
- Right front brake
- R-ABS actuator.

Brake Bleeding:

1. Connect a transparent vinyl tube to air bleeder valve.
2. Fully depress brake pedal several times.
3. With Brake pedal depressed, open air bleeder valve to release air.
4. Close air bleeder valve.
5. Release brake pedal slowly.
6. Repeat steps 2 through 5 until clear brake fluid comes out of air bleeder valve.
7. Tighten air air bleeder to the specified torque. 7-9 Nm (61-78 in lb)