Cylinder Head

Tightening procedure

a Tighten bolts to 29 Nm (3 kg-m, 22 ft-lb).
b Tighten bolts to 59 Nm (6 kg-m, 43 ft-lb).
c Loosen bolts completely.
d Tighten bolts to 29 Nm (3 kg-m, 22 ft-lb).
e Turn bolts 50 to 55 degrees clockwise or if angle wrench is not available, tighten bolts to 59±5 Nm (6+0.5 kg-m, 43.4 + 3.6 ft-lb).
f Tighten bolts (11 - 15) to 6.3 to 8.3 Nm (0.64 to 0.85 kg-m, 4.6 to 6.1 ft-lb).