Clutch: Service and Repair

Fig. 2 Bleeding Clutch Damper & Operating Cylinder:

Note: Bleed in the following order: Clutch Slave Cylinder, then Clutch Damper. Carefully monitor fluid level at master cylinder during bleeding operation.

1. Fill reservoir with recommended brake fluid.
2. Connect transparent vinyl tube to air bleeder valve as shown.
3. Fully depress clutch pedal several times.
4. With clutch pedal fully depressed, open bleeder valve to release air.
5. Close bleeder valve.
6. Repeat steps three through five until clear brake fluid comes out of bleeder valve.