Neutral Safety Switch: Testing and Inspection
INHIBITOR SWITCHInhibitor Switch Positions:
Inhibitor Switch Testing:
Test Chart:
Inhibitor Switch Testing:
1. Check continuity between terminals 1 and 2 and between terminals 3 and 4, 5, 6, 7, 8, 9 while moving selector lever through each position.
Inhibitor Switch Linkage:
2. If N.G., check again with manual control linkage disconnected from manual shaft of A/T assembly. - Refer to step 1.
3. If O.K. on step 2, adjust manual control linkage.
4. If N.G. on step 2, remove inhibitor switch from A/T and check continuity of inhibitor switch terminal. - Refer to step 1.
5. If O.K. on step 4, adjust inhibitor switch.
6. If N.G. on step 4, replace inhibitor switch.