Component Testing Procedures

Fig. 190 No. 1, 3, & 5 Fuel Injector Test:

INJECTORS #1, #3 & #5
1. Disconnect injector terminal.
2. Using an ohm meter measure resistance across terminals as shown in Fig. 190.
If not between 10 and 14 ohms, replace injector. Refer to COMPONENT REPAIR AND REPLACE PROCEDURES.

Fig. 191 No. 2, 4, & 6 Fuel Injector Test:

INJECTORS #2, #4 & #6
1. Disconnect sub-harness connectors (2) for injectors.
2. Using an ohm meter measure resistance across the terminals as shown in Fig. 191.
If not between 10 and 14 ohms, replace injector. Refer to COMPONENT REPAIR AND REPLACE PROCEDURES.