Disassembly

CENTER BEARING





1. Put match marks on flanges, and separate 2nd tube from 1st tube.





2. Put match marks on the flange and shaft.





3. Remove locking nut with Tool.
Tool number:
R18OA, R200A, H190A, C2OO
(2WD except Van and Wagon)
ST38O6OOO2 (J34311)
C2OO (Van and Wagon), H233B
KV381O47OO (J34311)





4. Remove companion flange with puller.





5. Remove center bearing with Tool and press.
Tool number: ST3OO31OOO (J22912-O1)

JOURNAL (71H and 8OB)

NOTE: 63A: Do not disassemble.





1. Put match marks on shaft and flange or yoke.





2. Remove snap ring.





3. Remove pushed out journal bearing by lightly tapping yoke with a hammer, taking care not to damage journal and yoke hole.





4. Remove bearing at opposite side in above operation.
Put marks on disassembled parts so that they can be reinstalled in their original positions from which they were removed.