Air Bleeder Screw: Locations

MAKE BLEED W/
MODEL BLEEDER FILL ENGINE SPECIAL
ENGINE TYPE LOCATION POINT @ RPM NOTICE

NISSAN

1989-90 Sentra, plug cylinder radiator off Recheck cold
Pulsar head

1991-92 Sentra, bolts(2) 1. cylinder 1.6L & 2.0L: Fill
NX: 1.6L head until coolant flows
2. heater from bleeders, hose then close. Jam outlet
open cap valve with
a U-shaped wire.
Run engine allowing
remaining air to vent
into coolant reservoir

2.0L 1. bolt thermostat radiator off (See above)
2. pipe housing &
cap
heater
hose

1990-92 bolt intake radiator off Bolt located
Axxess, Stanza manifold next to PCV valve.
plenum Recheck cold

1987-88 plug right head radiator off Plug is by PCV hose
200SX V6

1989-90 240SX bolt thermostat radiator off Recheck cold
housing

1990-91 300ZX plug radiator radiator off Recheck cold
top tank

1985-88 Maxima bolt heater pipe radiator off Recheck cold

1989-92 Maxima bolt intake radiator off Bolt located
manifold next to PCV valve.
plenum Recheck cold

1986-89 Pickup V6 plug heater pipe radiator off Plug is by battery

1990-92 Pickup: bolt # 1 intake radiator off Recheck cold
4-cyl. manifold
runner

V6 bolt intake radiator off Bolt located next
manifold to PCV valve.
plenum Recheck cold