Testing Fuel Gauge Sending Unit
- Remove sending unit from fuel tank. Measure resistance between terminals "G" (+) and "E" (-) of sending unit connector.
- Resistance values should change as position of fuel sending unit is changed. Resistance values should approximately equal those on FUEL GAUGE SENDING UNIT RESISTANCE table.
FUEL GAUGE SENDING UNIT RESISTANCE (OHMS)
| Application | Full | Half | Empty |
|---|---|---|---|
| 2WD | 4-8 | N/A | 89 |
| 4WD | 7-8 | 34-36 | 89-92 |