Clutch Disc: Testing and Inspection

INSPECTION
^ Check clutch disc for wear of facing.

Wear limit of facing surface to rivet head:
0.3 mm (0.012 in)





^ Check clutch disc for backlash of spline and runout of facing.

Maximum backlash of spline (at outer edge of disc):
240TBL 1.0 mm (0.039 in)
250TBL 1.0 mm (0.039 in)
Runout limit:
1.0 mm (0.039 in)
Distance of runout check point (from hub center)
240TBL 115 mm (4.53 in)
25OTBL 115 mm (4.53 in)

^ Check clutch disc for burns, discoloration or oil or grease leakage. Replace if necessary.