Vehicle Specific Information
VEHICLE SPECIFIC INFORMATION200 SX (1986.5-88)
Remove center console to disconnect the seat belt buckle switch.
Seat bolt torque 15-20 ft-lbs (21-26 Nm, 2.1-2.7kg-m)
Buckle mounting bolt torque 26-34 ft-lbs (35.8-45.6 Nm, 3.7-4.7 kg-m)
240SX (1989-91)
Seat bolt torque 32-41 ft-lbs (43-55 Nm, 4.4-5.6 kg-m)
Seat mounting nut torque 19-24 ft-lbs (25-32 Nm, 2.6-3.3 kg-m)
Buckle mounting bolt torque 32-41 ft-lbs (43-55 Nm, 4.4-5.6 kg-m)
TRUCK (1988-91)
Buckle mounting bolt torque 26-34 ft-lbs (35.8-45.6 Nm, 3.7-4.7 kg-m)
Note
The center seat belt position buckle on bench seat equipped trucks is not affected by this campaign.
PATHFINDER (1988-91)
The connector for the seat belt buckle is located under the center console and can be pulled out from under the console by gently lifting the edge of the console where the wires go under the edge. Always replace the connector after repairing the seat belt buckle.
Buckle mounting bolt torque 26-34 ft-lbs (35.8-45.6 Nm, 3.7-4.7 kg-m)
VAN (C22) (1987-90)
Buckle mounting bolt torque 26-34 ft-lbs (35.8-45.6 Nm, 3.7-4.7 kg-m)
SENTRA (1987-89, except Coupe)
Seat bolt torque 18-23 ft-lbs (25-31 Nm, 2.5-3.2 kg-m)
Buckle mounting bolt torque 26-34 ft-lbs (35.8-45.6 Nm, 3.7-4.7 kg-m)
SENTRA Coupe (1989-90)
Seat bolt torque 18-23 ft-lbs (25-31 Nm, 2.5-3.2 kg-m)
Buckle mounting bolt torque 32-41 ft-lbs (43-55 Nm, 4.4-5.6 kg-m)
SENTRA Sedan/Station Wagon (1990)
Remove center console to disconnect the seat belt buckle switch. Also remove the two rear seat mounting bolts to put slack in the carpet to make the switch wire routing easier.
Seat bolt torque 18-23 ft-lbs (25-31 Nm, 2.5-3.2 kg-m)
Buckle mounting bolt torque 32-41 ft-lbs (43-55 Nm, 4.4-5.6 kg-m)
SENTRA 2-Door (1991)
Seat bolt torque 32-41 ft-lbs (43-55 Nm, 4.4-5.6 kg-m)
Buckle mounting bolt torque 32-41 ft-lbs (43-55 Nm, 4.4-5.6 kg-m)