LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 1989 >> Sentra Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Axle Shaft Bearing & Oil Seal >> Removal (Pathfinder & Pickup W/Single Rear Wheel)

Removal (Pathfinder & Pickup W/Single Rear Wheel)

  1. Raise and support vehicle. Remove rear wheel assembly. Remove brake drum. Disconnect parking brake cable and hydraulic brake line from backing plate. Remove 4 nuts holding backing plate to rear axle case. Using Rear Axle Adapter (KV4010000) and Slide Hammer (ST36230000), pull out axle shaft assembly with backing plate assembly.
  2. Remove oil seal from rear axle case. Discard oil seal. Using screwdriver, straighten lock washer, securing lock nut on rear axle case side of backing plate. Position axle shaft in vise, using Rear Axle Adapter (KV40101000).
  3. Using Lock Nut Remover (ST38020000), remove bearing lock nut. Using hydraulic press and Bearing Puller (HT72480000), withdraw wheel bearing, bearing cage and backing plate. Remove oil seal in bearing cage of backing plate and discard.
scientia non olet · About LEMON Manuals