LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 1989 >> Sentra Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Axle Shaft Bearing & Oil Seal >> Removal (240SX & 300ZX)

Removal (240SX & 300ZX)

  1. Raise and support rear of vehicle. Remove rear wheel assembly. Remove caliper assembly. Remove disc brake rotor. Disconnect drive shaft from axle shaft. Remove wheel bearing lock nut with parking brake engaged.
  2. Draw out axle shaft using Slide Hammer (J-25840-A). Remove rear axle shaft. Remove companion flange and discard old grease seal.
scientia non olet · About LEMON Manuals