LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 1989 >> Sentra Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Overhaul >> Rear Brake Drum & Linings >> Disassembly (Except 240SX & 300ZX)

Disassembly (Except 240SX & 300ZX)

  1. Raise and support rear of vehicle. Remove rear wheel assembly. Release parking brake. Remove brake drum. Remove parking brake rear cable. Remove retainer, anti-rattle spring, spring seat and pin from primary brake shoe. Remove return springs and primary shoe. Remove secondary brake shoe. On Stanza, remove adjuster assembly.
  2. On Sentra, remove toggle lever spring. Remove clip, washer, spacer and toggle pin. Separate toggle lever and shoe. See Figure and Figure. On all models, note lining condition and location for proper installation.
NOTE: Minimum lining thickness is .059" (1.5 mm) on Maxima and .080" (2.0 mm) on all other models.
scientia non olet · About LEMON Manuals