Pulsar NX Series
- To check power source, turn ignition switch to "ON" position. Check voltage between terminal No. 20 and ground. See Figure and Figure. If there is 12 volts, go to step 3).
- If there is not 12 volts, check for blown fusible link or fuse. Check harness continuity between battery terminal and combination meter. Check for malfunctioning ignition relay and/or ignition switch.
- To check voltage regulator, measure voltage between terminal "C" and ground. See Figure. If there is not about 8 volts, replace voltage regulator. If there is about 8 volts, connect a jumper wire between terminal No. 9 and ground.
- Fuel gauge should operate from "EMPTY" to "FULL". If it does not, replace fuel gauge. If it does, perform FUEL TANK SENDING UNIT TEST . If sending unit is okay, repair or replace harness between combination meter and fuel gauge unit harness.
CAUTION:
Do not leave jumper wire between terminal No. 9 and ground connected for more than one minute.