Removal & Installation (200SX SE & 200SX XE)

1. Disconnect battery ground. Remove steering wheel. Remove steering column covers and combination switch. Remove screws from behind covers and lift up on cover lid.
2. Disconnect SMJ for instrument harness. Remove screws attaching combination meter to instrument panel. Release electrical connectors.
3. Remove combination meter from instrument panel. Speedometer cable will release when combination meter is removed from instrument panel. To install, reverse removal procedure. See Fig 1.

Fig 1: Exploded View of 200SX Instrument Panel

Courtesy of NISSAN MOTOR CO., U.S.A.