2WD Models

1. Raise and support front of vehicle.
2. Remove brake pads.
3. While rotating disc, torque wheel bearing locknut to 18-22 ft. lbs on all except Pickup models. On Pickup, torque to 25-29 ft. lbs.
4. Loosen locknut approximately 60° on all except Pickup models. On Pickup, loosen 45°. Install adjusting cap and align groove of nut with hole in spindle. If alignment cannot be obtained, change position of adjusting cap. Also, if alignment cannot be obtained, loosen locknut slightly, but not more than 15°.
5. Install brake pads.