Drivetrain - Pinion Height Adapter, Manual Update

9218nissan01

Models:
1987 & 1988 Truck
Pathfinder & Van

Section:
Propeller Shaft
& Differential Carrier

Classification:
PD88-001

Bulletin No.:
TS88-028

Date:
February 22, 1988


PINION HEIGHT ADAPTER


APPLIED MODELS:
1987 & 1988 Truck/Pathfinder (D21/WD21) 1987 & 1988 Van (C22)





Pages PD-90 of the 1987 and 1988 Truck/Pathfinder Service Manuals, and PD-16 of the 1987 and 1988 Van Service Manuals contain an incorrect pinion height adapter number for the C200 rear axle. J-34309-13 in Steps 7 and 10 should be J-34309-11. Please make this correction by hand-on subject Service Manuals as shown.


10. Select the correct standard pinion height adjusting washer thickness by using a standard gauge of 3.5 mm (0.138 in.) and your J-34309-01 feeler gauge. Measure the gap between the J-34309-11 "C200" pinion height adapter and the arbor.