Load Compensator: Testing and Inspection

NOTE: To determine which Load Sensing Valve System is applicable, refer to Load Compensator-Application and ID. Application and ID

CAUTION:
^ Do not reuse Load Sensing Valve once it is disassembled.
^ Replace damaged Load Sensing Valve as an assembly.
^ When disassembling, apply multi.purpose grease to all rubbing areas.

INSPECTION (L.S.V.-B type)

L.S.V. Test:

1. Set weight slowly on axle center.
Weight: 100 kg (221 lb.)

2. Install pressure gauge to front and rear brake.

L.S.V. Test:

3. Raise front brake pressure to 4,904 kPa (50 kg/cm2, 711 psi) and check rear brake pressure.

Rear brake pressure:
2,256-3,236 kPa (23 - 33 kg/cm21 327-469 psi)

4. Raise front brake pressure to 9,807 kPa (100 kg/cm2, 1,422 psi) and check rear brake pressure.

Rear brake pressure:
3,138-4,511 kPa (32-46kg/cm2,455-654psi)

If rear brake pressure is not within specification, refer to service and repair. Service and Repair