LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 1985 >> Stanza GL, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL Turbo - VIN [C] & 2.0L 4-CYL - VINS [H,P] >> Removal & Installation >> Cylinder Head >> Inspection

Cylinder Head: Inspection

  1. Check cylinder head for cracks, flaws, or damage. Replace as necessary. Inspect head and block mating surfaces for warpage. Warpage limit is .004" (.10 mm) or less.
  2. If beyond limit, refinish surface. Maximum surface grinding limit of head and/or block is .008" (.20 mm). Replace head and/or block if machined or warped beyond service limit.
NOTE: DO NOT  apply sealant to mating surfaces of cylinder block and head.
scientia non olet · About LEMON Manuals