LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 1985 >> Stanza GL, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL Turbo - VIN [C] & 2.0L 4-CYL - VINS [H,P] >> Overhaul >> Crankshaft >> Removal

1.8L 4-CYL Turbo - VIN [C] & 2.0L 4-CYL - VINS [H,P]: Overhaul: Crankshaft: Removal

  1. With engine removed from vehicle, remove cylinder head assembly and oil pan. Remove connecting rod cap nuts. Remove piston and connecting rod assemblies. Remove alternator and engine mount bracket.
  2. Remove crankshaft pulley, timing belt covers, belt tensioner, timing belt, and crankshaft sprocket. Remove oil pump and front oil seal.
  3. Remove clutch assembly, flywheel, and rear plate. Loosen main bearing cap bolts, in 2 stages, and then remove caps. Remove rear oil seal retainer assembly. Carefully lift out crankshaft.
NOTE: Keep main bearing caps in order for reassembly reference. Check all main and connecting rod bearings, using Plastigage method.
scientia non olet · About LEMON Manuals