Rear Brake Drum & Linings: Disassembly
- Raise and support vehicle. Remove rear wheel and tire. Remove brake drum. Remove parking brake rear cable. Remove retainer, anti-rattle spring, spring seat and pin from primary brake shoe.
- Remove return springs (and clip retainer on Sentra Diesel) and primary shoe. Remove secondary brake shoe and on Stanza, remove adjuster assembly. See Fig 1 .
- On Sentra models, remove toggle lever spring. Remove clip, washer, spacer and toggle pin. Separate toggle lever and shoe. See Fig 1 . On all models, note lining condition and location for proper installation.
Fig 1: Exploded View of Pulsar NX & Sentra Rear Drum Brake Assembly Stanza adjuster is on drum side of backing plate.
NOTE:
Minimum lining thickness is .059" (1.50 mm) for all models.