Steering Wheel & Horn Pad: Removal
- Use following list for removal of steering wheel for particular model:
- On B210 models, disconnect battery ground cable. On resin model steering wheels, remove bolts on rear side of steering wheel bar. Pull out pad. Disconnect electrical wires. On 3 spoke steering wheels pad just pulls (pops) off.
- On F10 models, disconnect battery ground. On Hatchback models, remove horn pad, contact plates and spring, and contact base plate. On other models, horn pad is removed by unscrewing bolts from rear side of steering wheel.
- On 200SX and 280Z models, disconnect battery ground. Push in on horn pad and rotate counterclockwise.
- On 510, 810 and Pickup models, disconnect battery ground. Remove 2 bolts on rear side of steering wheel bar and slide off horn pad.
- Index mark top of steering column with steering wheel. Remove wheel mounting nut. Use suitable puller and extract steering wheel.NOTE: Do not hammer on steering wheel. Pounding may cause damage to collapsible steering column.