Clutch Pressure Plate: Remove & Replace
WARNING: This page is about the 280Z Automatic Trans, which is a different variant/trim than selected.
DOES NOT include resurface Flywheel.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| w/Catalytic Converter | 4.2 | C | ||
| w/o Catalytic Converter | 3.9 | C | ||
| Combination Procedure: CLUTCH PILOT BEARING OR BUSHING: Remove & Replace: | ||||
| 0.3 | C | |||
| Combination Procedure: CLUTCH RELEASE BEARING: Remove & Replace: | ||||
| 0.2 | C | |||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.2 | C | |||