Diagnostic Trouble Code Chart
CAUTION:
During diagnosis, a DTC associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTCs. If DTCs are set, erase them all.
| DTC No. | Item | Reference |
|---|---|---|
| C1394 | INCOMP.learn neutral(SAS) | Refer to DIAGNOSTIC TROUBLE CODE CHART . |
| C1705 | LDW SW circuit low (short) | Refer to DIAGNOSIS . |
| C1707 | Implausible coding data | Refer to DIAGNOSTIC TROUBLE CODE CHART . |
| C1747 | Shift signal undetermined | |
| C1750 | Voltage out of range | |
| C1751 | ECU failure | |
| C1752 | Radar temperature out of range | |
| C1753 | Radar blockage detected | |
| C1754 | Radar calibration not completed | |
| C1777 | System fail detected (ASC) | |
| C1778 | Vehicle speed signal fail | |
| C1779 | Brake master cylinder PRS.signal | |
| C1781 | SAS fail | |
| C1782 | SAS signal fail | |
| C1784 | FCM switch fixed ON | |
| C1787 | APS signal | |
| C1788 | Longitudinal G sensor signal | |
| C1791 | Vehicle speed signal (invalid) | |
| C1792 | Brake M/C PRS. signal (invalid) | |
| C1793 | Lateral ACC. signal (invalid) | |
| C1794 | Longitudinal G signal (invalid) | |
| C1795 | Yawrate signal (invalid) | |
| C1796 | APS signal (invalid) | |
| C1798 | FCM control disabled (ASC) | |
| C1799 | FCM control disabled (ENGINE) | |
| C1809 | System temporary not available | |
| C2256 | Brake switch signal fail | |
| C2271 | SAS signal fail | |
| C2272 | Delta SAS signal fail | |
| C2276 | Brake switch signal | |
| C2292 | Auto calibration out of range | |
| C2298 | Ambient sensor signal | |
| C2299 | Implausible coding data | |
| U0100 | Engine CAN timeout | |
| U0101 | T/M CAN timeout | |
| U0121 | ABS/ASC CAN timeout | |
| U0126 | SAS CAN timeout | |
| U0141 | ETACS CAN timeout | Refer to DIAGNOSTIC TROUBLE CODE CHART . |
| U1190 | No receive fault detect signal | |
| U1195 | Coding not completed |