| Blind spot warning switch |
1 |
Sends the BSW (with LCA)/RCTA ON/OFF signal to the gateway-ECU. |
| Steering wheel sensor |
2 |
Sends the steering wheel angle signal to the gateway-ECU. |
| Selector lever assembly |
3 |
Informs the BSW-ECU of the selector lever status. |
| Combination meter |
4 |
Displays a relevant information on the information display and activates the tone alarm according to the request from the BSW-ECU. |
| BSW-ECU (Integrated with radar) |
5 |
- Determines whether the BSW (with LCA)/RCTA should be activated according to the results (such as distance) from the sensors, and sends the control request signals to the combination meter, door mirror indicator.
- There are two types of BSW-ECU; BSW-ECU (master) and BSW-ECU (slave). The BSW-ECU (master) and BSW-ECU (slave) communicate with each other via CAN. The BSW-ECU (master) communicates with the gateway-ECU via CAN.
|
| ASC-ECU |
6 |
Sends vehicle speed and ASC status signals to the BSW-ECU. |
| Gateway-ECU |
7 |
Communicates with the ASC-ECU, the TCM, the column switch assembly (Integrated with steering wheel sensor), the ETACS-ECU, the BSW ON/OFF switch status and the combination meter to request the BSW-ECU to control the system. |
| ETACS-ECU |
8 |
Informs the BSW-ECU of the turn switch status, etc. |
| Data link connector |
9 |
Is connected to scan tool (M.U.T.-III) to read the DTC and service data associated with the BSW-ECU. |
| Blind spot Warning light (Mirror indication) |
10 |
Is displayed when the BSW (with LCA)/RCTA are triggered. |
| Blind spot warning light (Multi information display screen on Combination meter) |
11 |
Is displayed when the BSW (with LCA)/RCTA is activated. |
| Rear cross traffic alert message (Multi information display on combination meter) |
12 |
Is displayed when the RCTA is triggered. |