Diagnostic Trouble Code Chart
CAUTION:
During diagnosis, a DTC associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTC(s). If DTC(s) are set, erase them all.
| DTC | Item | Reference |
|---|---|---|
| C1078 | Tire with incorrect diameter equipped | |
| C1456 | Wiring harness or coupling coil overcurrent failure | |
| C145A | Wiring harness or coupling coil short circuit failure | |
| C145D | Wiring harness or coupling open circuit failure | |
| C145F | Coupling overload | |
| C1460 | Drive mode selector circuit failure | |
| C2100 | Abnormal battery voltage (too low) | |
| C2101 | Abnormal battery voltage (too high) | |
| C211C | Abnormal IG1 power supply low voltage | |
| C211D | Abnormal IG1 power supply high voltage | |
| C211E | Abnormal power supply voltage (too low) | |
| C211F | Abnormal power supply voltage (too high) | |
| C2208 | AWD-ECU internal error | |
| U0001 | Bus-off error | |
| U0100 | Engine CAN time-out | |
| U0101 | T/M CAN time-out | |
| U0121 | ASC CAN time-out | |
| U0141 | ETACS CAN time-out | |
| U0401 | Engine CAN data error | |
| U0415 | ASC CAN data error | |
| U113C | Wheel speed sensor data error | |
| U1415 | Variant coding not implemented |