Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the Mirage Carbonite Edition, which is a different variant/trim than selected.

Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies To	Note	Standard Hours	Skill Level
All		2.2	B
Front,Both Sides		1.0	B
Rear,Both Sides		1.6	B
Combination Procedure: BRAKE DRUM (REMOVED): Refinish: DOES NOT include grind hot spots.
Each Additional		0.2	B
One		0.3	B
Combination Procedure: BRAKE HOSE: Replace: Includes: Bleed System.
Each Additional		0.2	B
One		0.3	B
Combination Procedure: BRAKE SYSTEM: Bleed: NOTE: This operation is not to be used with any other operation(s) containing brake fluid bleed.
		0.2	B
Combination Procedure: CALIPER: Overhaul: Includes: Bleed System.
One		0.5	B
Combination Procedure: CALIPER: Replace: Includes: Bleed System.
One		0.3	B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
		0.5	B
Combination Procedure: DISC ROTOR: Correct:
Lateral Runout,Each	Correct Rotor lateral runout by indexing.	0.2	B
Combination Procedure: DISC ROTOR: Remove & Install or Remove & Replace:
Each		0.1	B
Combination Procedure: DISC ROTOR (REMOVED): Refinish: DOES NOT include grind hot spots.
Each Additional		0.3	B
One		0.5	B
Combination Procedure: DRUM: Remove & Install or Remove & Replace:
Each	Includes: R&I Wheel Bearing.	0.2	B
Combination Procedure: HUB & ROTOR DISC: Clean & Inspect:
Corrosion,Each	Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor.	0.2	B
Combination Procedure: WHEEL BEARING: Replace:
Front,One	Includes: R&I Steering Knuckle.	1.2	B
Rear,One		0.2	B
Combination Procedure: WHEEL CYLINDER: Overhaul: Includes: Bleed System.
Off Vehicle,One		0.3	B
On Vehicle,One		0.3	B
Combination Procedure: WHEEL CYLINDER: Replace: Includes: Bleed System.
One		0.3	B