Inspection Procedure 4: No DTC is set even when the AWD/LOCK Indicator Lights Flash: Diagnosis
WARNING: This page is about a different variant/trim than selected.
- STEP 1. Check if 4WD/LOCK Indicator Lights flash simultaneously
- Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
- Check that the 4WD/LOCK indicator lights flash simultaneously when the drive mode selector is switched to 4WD (AWD) position, or LOCK position.
Q: Does the 4WD/LOCK Indicator Lights flash simultaneously?
YES :
- When the drive system fluid temperature warning display illuminates in the combination meter, cool down the electronic control coupling.
- When the drive system fluid temperature warning display does not illuminate in the combination meter, referring to "Inspection Procedure 1: Scan tool MB991958 cannot Communicate with the Electronic Control AWD System<ECU power supply circuit system check>", perform the check SYMPTOM PROCEDURES .
NO : Referring to the Inspection Chart for Trouble Symptoms, perform the check TROUBLE SYMPTOM CHART .