LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical (2.0L Engine Non-Turbo) - Lancer) >> Oil Pan >> Removal And Installation >> Removal Service Points >> << B >> Engine Oil Pan Removal

<< B >> Engine Oil Pan Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine oil pan mounting bolts.
    CAUTION: Do not forcibly drive in special tool MD998727 to avoid damage to the engine oil pan seal surface of cylinder block assembly.
  2. Insert special tool MD998727 to the engine oil pan removal groove of the cylinder block assembly.
  3. Lightly tap the special tool MD998727 with a hammer to slide the engine oil pan seal surface, cut off the liquid gasket, and remove the engine oil pan.
    Fig 1: Identifying Engine Oil Pan, Removal Groove And Crankshaft Pulley
    G06480962Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Identifying Engine Oil Filter, Removal Groove And Crankshaft Pulley
    G06480963Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 3: Inserting Special Tool MD998727 To Engine Oil Pan
    G06480964Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals