LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical (2.0L Engine Non-Turbo) - Lancer) >> Engine Assembly >> Removal And Installation >> Removal Service Points >> << D >> Manual Transaxle Assembly/CVT Assembly Removal

<< D >> Manual Transaxle Assembly/CVT Assembly Removal

WARNING: This page is about a different variant/trim than selected.
  1. Install the front end upper bar bolts to the position as shown in the figure.
  2. Remove the transaxle assembly (Refer to TRANSAXLE ASSEMBLY ) < M/T > or (Refer to TRANSAXLE ASSEMBLY ) < CVT. >
    Fig 1: Locating Front End Upper Bar Bolts
    G09619062Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals