LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical (2.0L Engine Non-Turbo) - Lancer) >> Crankshaft Pulley >> Removal And Installation >> Installation Service Points >> >> B << Drive Belt Installation

>> B << Drive Belt Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • To reuse the drive belt, install it by aligning the arrow mark on the backside of belt marked at the removal with the rotating direction.
  • Check that the notches of the notched pulley and the notches of the drive belt are fit correctly.
  • Check that the drive belt is installed in the centre of the flat surface of the flat pulley.
Fig 1: Identifying Proper Drive Belt Installation
G09618953Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Install the drive belt to each pulley as shown in the figure.
    WARNING: Be sure to set the tool to the hexagonal part securely to prevent the tool from falling off because the tension of the auto-tensioner is high.
    Fig 2: Identifying Drive Belt Routing
    G09618954Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Securely set the tool to the hexagonal part of the auto-tensioner.
  3. Rotate the auto-tensioner anti-clockwise and remove the L-shaped hexagon wrench fixing the auto-tensioner.
  4. Apply tension to the drive belt while slowly turning the auto-tensioner clockwise.
    Fig 3: Setting Tool To Hexagonal Part Of Auto-Tensioner
    G09618949Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals