LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical (2.0L Engine Non-Turbo) - Lancer) >> Crankshaft Oil Seal >> Removal And Installation >> Installation Service Points >> >> A << Crankshaft Rear Oil Seal Installation

>> A << Crankshaft Rear Oil Seal Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply a small amount of engine oil to the entire inner diameter of the crankshaft rear oil seal lip.
  2. Using special tool MD998718, press in the crankshaft rear oil seal up to the cylinder block end surface.
    Fig 1: Identifying Crankshaft Rear Oil Seal, Cylinder Block And Crankshaft
    G07027006Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals