<< B >> Number 1 Cylinder Compression Top Dead Center Setting
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Never turn the crankshaft counterclockwise.
- Turn the crankshaft clockwise so that the camshaft sprocket timing marks become horizontal to the cylinder head upper surface, and set the number 1 cylinder to the top dead center of compression. At this time, check that the crankshaft pulley timing mark is in the 0-degree angle position of the ignition timing indicator of the timing chain case assembly.
- Put paint marks on both the camshaft sprocket and timing chain at the position of camshaft sprocket timing chain mating mark (circular hole.)