LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical (2.0L Engine Non-Turbo) - Lancer) >> Camshaft >> Removal And Installation >> Installation Service Points >> >> B << Camshaft/Camshaft Sprocket Installation

>> B << Camshaft/Camshaft Sprocket Installation

WARNING: This page is about a different variant/trim than selected.
  1. Use a monkey wrench to secure the hexagon part of the camshaft in the same manner as removal.
    Fig 1: Installing Camshaft/Camshaft Sprocket
    G06671177Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Apply an adequate and minimum amount of engine oil to the camshaft and camshaft sprocket as shown in the figure.
  3. Install the camshaft sprocket to the camshaft.
  4. Apply an adequate and minimum amount of engine oil to the camshaft sprocket mounting bolt.
  5. Tighten the camshaft sprocket mounting bolt to the specified torque.

    Tightening torque: 59 ± 5 N.m (44 ± 3 ft-lb) 

    Fig 2: Identifying Engine Oil Applying Area To Camshaft And Camshaft Sprocket
    G09618971Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals